Our range of demulsifiers offer full phase separation of waste garage oils, slop and ballast fuels.
Treatment outcomes are designed to achieve the maximum yield of dry oil for recycling.
KEY PROPERTIES
Reverse Demulsifiers are designed to separate oil emulsions into three phases:-
- Oil Phase
- Biological
- Solids
|
− For Recycling.
− Discharge to Consent.
− Land Fill.
|
Without the use of Reverse Demulsifiers disposal of waste oil-in-water emulsions would be environmentally
unfriendly and prohibitive in cost.
KEY PRODUCTS
We have a wide range of waste oil treatment demulsifiers, reverse demulsifiers and dispersants.
We offer a free laboratory service to advise on the selection of the correct Demulsifiers appropriate to the emulsion being treated.
- WT 507
- WT 525
- WT 654
- WT 1621
|
− Polishing agent to remove light oil in water
− Separation of Cutting oil emulsions
− Reverse Demulsifier
− Flocculant |
[MSDS]
[MSDS]
[MSDS]
[MSDS] |
APPLICATION
Typical treatment dosages vary widely from 10ppm to 2000ppm depending upon the emulsions properties.
Oil-in-water emulsions are treated at ambient temperature.
For best results they should be added at a point of high turbulance to guarantee complete dispersion within the treatment tank.
After dosing all dosing and pumping equipment should be switched off to allow phase separation to take place in a turbulant free environment.
AVAILABLE PACK SIZES
1000Ltr, 200Ltr.
SAFE HANDLING AND STORAGE
Store in original containers and avoid extremes of temperature.
For guidance on handling and disposal see Material Safety Data Sheet. |